Things to test when your washing machine is not filling with water:
Water Inlet Hose Washing Machine
Washer is connected to the household water supply by inlet hose. These plastic tubes usually have a wire mesh at the end of the tube to prevent dirt and sediment from entering the machine. If the washer does not fill, you must first check whether the inlet hose is not kinked. If this does not solve the problem, you should put the end of the hose in a bucket and turn on the faucet to verify that there is adequate pressure. If there is a problem, you will have to clean the inlet hose.
Washing Machine Water Inlet Valve
This valve supplies both hot and cold water to rinse and wash. The valve is controlled by the electronic or timer control, water level switch, and cycle selector. If the washing machine is not filling hot and cold water, you must check the condition of the inlet valve. This can be done using a multi-meter. Since this is a live voltage test, if must be performed by washing machine service technician.
Lid Switch
The lid switch is a safety device that prevents the motor circuit from operating when machine lid is open. When the switch fails, power cannot be supplied to the inlet valve. If the water inlet valve of the device is not receiving power, it indicates that lid switch is damaged. The switch is usually beneath the main top of the washer. Before checking the condition of the lid switch, make sure you disconnect the power supply to the machine. You will need a multi-meter to test the status of the lid switch. Residential users who find it difficult to perform this test, you could get help from washer repair technician.
Water Temperature or Selector Switch
The selector or the water temperature switch selects the water temperature for the rinse and wash portion of the cycle. The switch provides power to the solenoids on the water inlet valve. If you don’t have power on these solenoids, in indicates that selector switch may be at fault. If you are planning to check the condition of the switch using a multimeter, make sure you remove the power supply to the machine. Alternatively, you can get help from washing machine repairman to solve this problem.
Pressure Switch
The water level pressure switch is a part of the inlet valve circuit. This part is usually located behind the control panel and has air or a hose dome tube that connects it to the wash tub. If the washing machine uses electronic controls, this switch is located under the wash tub. You will need a multi-meter to check the condition of the switch. If the switch is faulty, make sure you get the same switch as installing the wrong switch can be hazardous.
Locations We Service Includes:
Coral Springs, Dania, Fort Lauderdale Appliance Repair, Cooper City, Washer Repair, Dryer Repair, Residential Appliance Service Company, Hallandale, Weston, Appliance Service Technician, Margate, Deerfield Beach Appliance Repair Companies, Lauderhill, Lauderdale Lakes, Pembroke Pines, Oakland Park, Parkland, Sunrise, Whirlpool Appliance Repair, Clothes Washer Repair, Tamarac, Appliance Repair Hollywood Florida